Model 2500A225C
Rev A
53
4.4.9
Low or No Power Output (RF Test)
NOTE: The DC Tests specified in Section 4.4.8 should be completed before conducting the RF tests specified
in the following sections.
1.
The Model 2500A225C’s typical gain response at 0 dBm input and -20 dBm input is shown in Figures 4-1
and 4-2. The actual gain may vary considerably from that shown in Figure 4-
1 but should be ≥
63 dBm.
Figure 4-
2 should be ≥ 6
6 dBm.
Figure 4-1. Typical Response at 0 dBm Input
Figure 4-2. Typical Response at -20 dBm Input
Summary of Contents for 0053007
