57
Sequencer Configuration
Sequencer Config —
After you have assigned physical Smooth Flite output channels (S01 through S26) to
any of the 9 gear sequencer channels you can then configure how the sequencer performs.
The Quick Start method for setting up a sequencer is as follows:
1)
Assign a Master sequencer Channel. [Page 52]
2)
Assign Physical output channels. [Page 53]
3)
Adjust the parameters of the Smooth Flite physical output channels to set gear and doors in the
correct position. [Page 54]
4)
Set up sequencer steps. [Page 58]
5)
Test sequencer operation using the Test page. [Page 59]
6)
Test sequencer operation using the transmitter.
So far we have described points
1
—
3.
From here on we will talk about how to get the best out of the
sequencer stepping operation for a gear up sequence and gear down sequence.
For this example we will use a simple setup of 1 landing Gear air valve and one Inner Door air valve.
Once you understand this basic operation you can easily expand to multi servo fear doors etc. In the
previous pages we have explained how to assign a
“
landing Gear
”
channel. Please repeat the same
process but this time assign an
“
Inner Doors
”
channel. Once you have these two assignments done you
will be ready to start sequencing.
From the Sequencer assign page tap
[Sequencer Config]
. You should see the page shown directly below.
Tap the green button marked with channel
[26]
. You
will notice that this button changes to
red or Gear
Up state
.
Alternate tapping of the same button will alternate
the buttons between
(Gear Up—Red)
and
(Gear
Down—Green)
states.
This is how we set the state of the landing gear and
doors for each step of the sequence.
(Continued over page)
Summary of Contents for SmoothFlite RRS
Page 1: ...SmoothFlite RRS User Guide ...
Page 26: ...26 Page Intentionally Left Blank ...
Page 65: ...65 Notes ...
