PY500AC SLIDING GATE OPERATOR
10
8.
8.
8.
8. Porgramming
Porgramming
Porgramming
Porgramming Process
Process
Process
Process
Table of the DIP-switch (SW2)
�
Set auto-close function:
(This feature can be selected to make the gate stay open for some seconds
before it automatically closes. The auto-close time can be adjusted to between 0 and 44 seconds.):
Turn on the second and the third DIP-switch (See Fig.8) to ON position. Press the remote control
button (button 1, button 2 or button 3) that has been programmed to open the gate (see
V
V
V
Verify
erify
erify
erify open
open
open
open
direction
direction
direction
direction
section). Stop the gate at any position by pressing the same button, wait a few seconds
according to your requirements (the range is 1~44 sec.), this period of time is regarded as ‘auto-
close time’. Close the gate by pressing the same button. Press the button again to stop the gate or
the gate will stop automatically at its closed position if the limit switch is reached. After this setup is
complete, return DIP-switch 3 to OFF position immediately. Thus the
auto-close
auto-close
auto-close
auto-close function
function
function
function
has been
set.
�
Cancel auto-close function:
Turn on the second and the third DIP-switch (see Fig.8) to ON position.
Press the remote control button (button 1, button 2 or button 3) that has been programmed to open
the gate (see
Verify
Verify
Verify
Verify open
open
open
open direction
direction
direction
direction
section). Stop the gate at any position by pressing the same
button, wait until the gate close automatically (45 sec.). Press the same button to stop the gate or
the gate will stop automatically at its closed position if the limit switch is reached. After this setup is
complete, return DIP-switch 3 to OFF position immediately. Thus the auto-close function has been
canceled.
�
Pedestrian mode:
Pedestrian mode can be used to open gate about 0.3~1.5 meters for people pass
Position
DIP-switch
Function SET
1
ON
Limit switch mode is NC.
OFF
Limit switch mode is NO.
2
ON
Auto-close function and auto-close function of pedestrian mode
are available.
OFF
Both Auto-close function and auto-close function of pedestrian
mode are shut off.
3
ON
Programming / In this position the control board is in programming
condition, NOT USE condition.
OFF
Normal / In this position the control board can be normally used.
