PY500AC SLIDING GATE OPERATOR
11
through.
Set width of pedestrian mode:
Turn on the second and the third DIP-switch (See Fig.9) to ON position.
Press button 4 to open the gate (see
Verify
Verify
Verify
Verify open
open
open
open direction
direction
direction
direction
section), Wait until the gate travels the
distance according to your requirements (the distance range is 0.3m~1.5m or wait for 3~10 sec.), it is
regarded as ‘the width of pedestrian mode’. Then press the same button/button 4 to stop the gate,
wait for some seconds (1~ 44 sec.). Close the gate by pressing the same button/button 4. Press the
same button again to stop the gate or the gate will stop automatically at its closed position if the limit
switch is reached. After this setup is complete, return DIP-switch 3 to OFF position immediately. Thus
the
width
width
width
width of
of
of
of pedestrian
pedestrian
pedestrian
pedestrian mode
mode
mode
mode
has been set.
If you open the gate with button 4, the gate will stop at the expected position that you have set.
Set
Set
Set
Set auto-close
auto-close
auto-close
auto-close function
function
function
function of
of
of
of pedestrian
pedestrian
pedestrian
pedestrian mode:
mode:
mode:
mode:
Turn on the second and the third DIP-switch (See
Fig.9) to ON position. Press button 4 to open the gate (see
Verify
Verify
Verify
Verify open
open
open
open direction
direction
direction
direction
section), wait some
seconds (3~10 sec.). Then press the same button/button 4 to stop the gate, wait some seconds
according to your requirements (1~44 sec.), this period of time is regarded as ‘auto-close time of
pedestrian mode’. Close the gate by pressing the same button/button 4. Press the same button again
to stop the gate or the gate will stop automatically at its closed position if the limit switch is reached.
After this setup is complete, return DIP-switch 3 to OFF position immediately. Thus the
auto-close
auto-close
auto-close
auto-close
function
function
function
function of
of
of
of pedestrian
pedestrian
pedestrian
pedestrian mode
mode
mode
mode
has been set.
Note: the new width of pedestrian mode has been re-programmed in the device and replaced the
original width you have set in
Set
Set
Set
Set width
width
width
width of
of
of
of pedestrian
pedestrian
pedestrian
pedestrian mode
mode
mode
mode
section.
If you open the gate with button 4, the gate will stop at the new expected position that you have set,
after some seconds as what you have set, the gate will close automatically.
�
Cancel width / auto-close function of pedestrian mode
Cancel both width and auto-close function of pedestrian mode: Turn on the second and the third DIP-
switch (See Fig.9) to ON position. Press button 4 to open the gate (see
Verify
Verify
Verify
Verify open
open
open
open direction
direction
direction
direction
section). Wait for more than 15 sec.. Then press the same button/button 4 to stop the gate. Wait until
the gate close automatically (45 sec.). Press the same button to stop the gate or the gate will stop
automatically at its closed position if the limit switch is reached. After this setup is complete, return
DIP-switch 3 to OFF position immediately. Thus the width and auto-close function of pedestrian mode
have been canceled.
