PY500AC SLIDING GATE OPERATOR
4
Gate operator
Gear
Groundsill
Input power
Plain washer
Nut
Spring washer
Nut
Fig.2
Operator base (see Fig.3)
After the concrete has hardened, mount the gate operator base to the concrete pad. Verify that the base
is properly leveled.
Using bolts and washers mount the gate operator to the base and insert the cover. Check the operator
and make sure it is lined up with the gate.
Fig.3
Installation
Installation
Installation
Installation of
of
of
of Rack
Rack
Rack
Rack
�
Fix the three nuts (in the same package with rack) on the rack element.
�
Lay the first piece of rack on the gear and weld the first nut on the gate.
�
Move the gate manually, checking if the rack is resting on the gear, and weld the second and third nut.
�
Bring another rack element near to the previous one. Move the gate manually and weld the three nuts
as the first rack, thus proceeding until the gate is fully covered.
