PY500AC SLIDING GATE OPERATOR
8
For three-button switch installation, use the terminals for multi-channel mode. Connect open wire of
external button switch to ‘OPEN’ of terminal X1, connect close wire of switch to ‘CLOSE’, connect
stop wire of switch to ‘STOP’, connect common wire of switch to ‘COM’.
Common
Stop
Close
Open
Three-button switch
OPEN
CLOSE
STOP
COM
OSC
Keypad
OSC
COM
STOP
CLOSE
OPEN
Control board
terminal block
Control board
terminal block
Single-button switch
terminal X1
terminal X1
Fig.10
Motor and capacitor (Terminal X7, X6): V (com), U (Positive direction), W (Opposite direction), E
(grounding), C (capacitor)
Fi
Motor
W
Terminal X7
E
W
Control board
Terminal X6
C
C
Capacitor
V
U
V
U
Fig.11
7.
7.
7.
7. Tuning
Tuning
Tuning
Tuning and
and
and
and operation
operation
operation
operation
Remote control
�
The remote control works in a single channel mode. It has four buttons. See Fig.12 Remote
transmitter. The function of button 1, button 2, and button3 are the same. With each press of the
remote control button which has been programmed, the gate will close, stop, open or stop cycle.
Button 4 is available for pedestrian mode. Note: if you canceled the pedestrian mode, the function
of button 4 is same as the other three buttons.
�
You can program/learn button 1, button 2, button 3 individually. You also can program/learn two
buttons or three buttons together, but you need repeat the program/learn process if you want to use
more than one button.
