18
Galaxy 3 Operating Manual
4. Use a regular flat cross over phone line as the
network cable for boards less that 15' away.
For dart machines that are more than 15' away use
round phone line with modular jacks. Use a flat
phone line to go from the modular jacks to the
dart machines.
5. The "network line" must alternate between COMM
IN to COMM OUT between dart machines.
See Section 3.5.
Note: If this is not done your network will not function
properly.
Section 7
Network Communications
A network can be set up between multiple boards in a location
so that you only need to use one board to communicate with
LeagueLeader. There are several ways this can be done.
7.1 Connecting to a Galaxy II
The Galaxy 3 can be connected to a Galaxy II/Galaxy II.5
network using a crossover phone line. Galaxy 3’s should
always be the master of the network.
1. Set the dip switches on the Galaxy III’s IOB (see 3.5)
so that it is in the MASTER position.
2. Set the dip switches on the end dart machines so that 3
is on.
3. Set all of the dip switches on any middle boards to
OFF.
Middle Boards
End Board
6.4 Setting up a Dialup Modem
The Galaxy 3’s can be set up to call out using a dialup
modem. The Galaxy 3 will use a normal analog phone line
to send and retrieve data from LeagueLeader.
Securing Screw
PCI Analog Modem
Galaxy 3 Ground Plane With a PCI Analog Modem
USB Cable
USB Analog Modem
Galaxy 3 Ground Plane With a USB Analog Modem
1. Unplug the Galaxy 3.
2. Unlock and open the bezel and monitor.
3. Plug in the modem on to the motherboard. See A1
(page 19) for our list of recommended Modems.
a. If it’s a PCI modem secure the PCI Card to the
bracket with a screw.
b. If its a USB modem, plug the USB cable into the
open USB port underneath the ethernet port.
Ethernet Port
4. Open the
Service Menu
.
5. Select
Communications
.
6. Select
LeagueLeader Setup
.
7. Select
Modem (Internet)
for the Connection Method.
8. Select
LeagueLeader Account Settings
. In this menu,
enter in your FTP Username and Password.
9. Enter in your ISP Phone Number. This can be gotten
from www.dialupusa.net.
10. Enter in your ISP Username and Password. These you
were given after you signed up for LeagueLeader.
11. Click
Return to Previous Menu
.
12. Click Perform Update to test the connection. This will
force a call to LeagueLeader and download any files
ready to be downloaded.
Master Board
16. Select
Return to Previous Menu
once finished.
17. Select
Return to Previous Menu
again.
18. Select
LeagueLeader Settings.
19.
Connection Method
should be already selected for
you, select
LeagueLeader Account Settings
.
20. Input your LeagueLeader FTP Settings.
21. Once all finished, select
Return to Previous Menu
.
22. Select
Perform Update.
Summary of Contents for galaxy 3
Page 36: ......
