DEFRA Stove Installation and User Guide
Figure 1: Fitting the flue outlet for a rear flue configuration.
Figure 2: Fitting the flue outlet for a top flue configuration.
The outlet pipe flange is pre fitted with a gasket rope seal. Additional
fire cement may be added if required.
The flue pipe assembly is secured in place with four M5 bolts (supplied).
Tighten bolts diagonally and evenly to ensure full compression of the gasket
but do not over tighten.
Place appliance on the hearth and make sure that it is level and does
not rock.
Connect the chimney ensuring all joints are sealed with fire cement.
Note : The flue pipe must be fitted inside the outlet spigot. Failure to
do so could result in the spillage of condensation running down the flue,
(see figure 3 on the next page)
BK575 Rev02
5