Technical data
VECTOPOWER® VP600....
Modified: 2016.10.12 by Andreas Mangold
Printed: 2016.10.12
VECTOPOWER_VP0x00_xxxA1_Wx_xxx_Installationsanleitung_v1_20_en.doc
50
ARADEX
ARADEX
AG
ARADEX-AG
Ziegelwaldstr. 3
73547 Lorch Germany
Tel.: + 49/ (0)7172/ 9181-0
Hotline:
Fax: + 49/ (0)7172/ 9181-91
E-Mail: info@aradex.com
http:/ / www.aradex.com
+ 49/ (0)700-
In
terlock
co
n-
ne
cti
on
19
Interlock_In
Currently without function
Input
20
Interlock_Out Currently without function
Output
Te
mperatu
re
se
ns
ors,
NTC
type
6
NTC1
NTC temperature sensor no. 1
Input
7
NTC2
NTC temperature sensor no. 2
Input
18
NTC_GND
Ground for NTC temperature
sensors
Input
A
nalo
g
inp
uts
21
An_U1+
Analog voltage input no. 1 plus Input
22
An_U1-
Analog voltage input no. 1 mi-
nus
Input
8
AN_I1+
Analog current input no. 1 plus Input
23
An_I1-
Analog current input no. 1 mi-
nus
Input
The pin number assignment is printed on the connector.
The pin assignment given here is available in the maximum expansion stage. The specif-
ic pin assignment of a VECTOPOWER
®
type can be found in the data sheet of your VEC-
TOPOWER
®
.
3.7.3
ST2, ST3, ST4: Customer-specific connection for logic signals
These connectors provide up to 17 pins each.
If the function "Sensorless", "Generator", or "AFE" is used, a single connector must be
used to connect the voltage measurement for the motor phases. See chapter 3.7.4.
For the connectors of the logic signal type: A type P insert is installed in the device, and
the mating connector must therefore be type E. Please note!
These connectors can be configured on the homepage of Intercontec
Produkt GmbH with the "Configurator". The connector series that is used
is the 623.