7
8 0 0 8 A N D I R I D I U M U S E R G U I D E
©2012 Indy Audio Labs, LLC all rights reserved / Revision20130220
Document No. 1000571
2 - System Controller (RS-232) Input:
The network
module section contains an RS-232 DB-9 connector for
interface to most external system controllers. Contact
Indy Audio Labs to verify compatibility with a particular
manufacturer’s control system.
3 - Ethernet Network Active LED:
The Ethernet
Network Active LED illuminates green with an active
network connection between the Aragon amplifier and a
network switch or router.
4 - Ethernet Jack:
The Ethernet jack enables con-
nection to either an external system controller or to a
standard home Ethernet 10/100 network switch or router
port. Control and status monitoring of the amplifier using
any device with a web browser is supported via the web
server embedded in the Aragon amplifier.
Feet:
Heavy-duty thermoplastic rubber feet ensure good
underside airflow, isolate your amplifier from external
vibration and protect the surface finish of AV furniture
underneath.
placement
and setup
An enjoyable home entertainment experience always
begins with carefully planned placement and setup of
system components. This section will provide guidance
on how to best install your new Aragon amplifier.
Shelf Mounting
When planning to mount on a shelf, be aware of the
physical dimensions of your Aragon amplifier as outlined
in the section entitled
Technical Specifications, p16
.
It is ALWAYS advisable to:
1. Provide ample space above the unit (1-2 inches is
the minimum preferred)
2. Provide plenty of room (at least 1-2 inches)
between the sides of the unit at nearby surfaces
or other components
3. Locate the unit near an AC outlet or power condition-
er and avoid using extension cords or power strips
4. Locate the amplifier as close as possible to the pre-
amp or pre-processor
5. Use as short length wire leads as practical, espe-
cially on the amplifier inputs
6. Connect the amplifier to the same mains circuit as
the pre-amplifier
7. Insert the included XLR shorting plugs whenever
using the RCA (unbalanced) inputs
It is NEVER advisable to:
1. Enclose the unit in a cabinet without air flow or ad-
equate ventilation, particularly across the heat fins
along the side and back of the unit.
2. Place the unit near a source of moisture such as a
window or a live plant
3. Place other components in a stack on top of
the amplifier
4. Place the amplifier on a carpeted surface
5. Remove the safety ground connector from the
AC mains cord
