ARAI HELMET
13
To remove/replace cheekpads
When first servicing the cheek pads, it is
suggested that you do only one at a time so that
the other can be used as reinstallation guide.
To remove cheek pads first undo chinstrap.
NOTE: Before removing the cheek pads, be
sure to lift up the neck roll tab, which is inserted
under the black covering at the forward lower
edge of the cheek pad assembly. This should
be re-inserted after reinstalling the cheek
pad, except for G-type helmets such as
Signet/GT and Maverick. Hereby the tabs
should not be removed at all!!
Pull pad toward the rear of the helmet, then
inward to release and slide it off the strap.
Installation in reversed order, ensure that
chinstrap is in the correct position! WARNING:
Never use petrol, thinner, benzene or any
other solvents as these can adversely affect the
shock absorbing liner and plastic components.