background image

 

Page 

4

 of 

5

 

 

OEM INTEGRATION INSTRUCTIONS  

 
 

This  device  complies  with  CFR47,  subpart  C,  paragraph  15.247  FCC  Rules.  This  enables  the  Aranet  Radio 
Module TDSPRMU1 to be incorporated within a finished product and utilize TDSPRMU1 certification for the 
finished product with the following conditions:  
 

(1)

 

the module must be installed in the host equipment such that 20 cm is maintained between the 
antenna and users, and the transmitter module may not be co-located with any other transmitter 
or antenna;  

(2)

 

the only antenna to be used is the integrated PCB antenna, external antennas are not supported;  

(3)

 

the  finished  product  will  display  a  label  which  is  directly  visible  as  follows: 

Contains FCC ID: W9Z-ARANETRM

  

Please note that although the radio characteristics are covered by the TDSPRMU1 modular FCC ID of the 
grant, it is still the responsibility of the manufacturer to perform final checks on the product, such as ensuring 
the radiated transmitted power is within limits, and to assess the worst case spurious emission is within the 
FCC requirements of CFR47 Part 15.  
 

 
 
 

FCC Declaration of Conformity  

 
 

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:  

 
(1)

 

This device may not cause harmful interference.  

(2)

 

This  device  must  accept  any  interference  received,  including  interference  that  may  cause 
undesired operation.  

 
 

CAUTION: Changes or modifications not expressly approved by the party responsible for compliance could 
void the user's authority to operate the equipment.  
 
 
NOTE:  This  equipment  has  been  tested  and  found  to  comply  with  the  limits  for  a  Class  B  digital  device, 
pursuant  to Part 15 of the FCC Rules. These  limits are  designed to provide reasonable protection against 
harmful  interference  in  a  residential  installation.  This  equipment  generates  uses  and  can  radiate  radio 
frequency  energy  and,  if  not  installed  and  used  in  accordance  with  the  instructions,  may  cause  harmful 
interference to radio communications. However, there is no guarantee that interference will not occur in a 
particular installation. If this equipment does cause  harmful interference to radio or television reception, 

Summary of Contents for TDSPRMU1






Reviews: