©2016 Arbor ScIentIfIc. All rIghtS reServed.
Po box 2750, Ann Arbor, MI 48106-2750
t
800 367-6695 www.ArborScI.coM
Rotate the carousel until the desired tube is at the
energizing station located in the front of the unit.
Turn on the power switch. The discharge will now strike
and run.
Changing the selected tube
The selected tube may be changed without turning the
power supply off. Simply rotate the carousel (holding
the partition between stations) until the new selection
is in the energizing station.
DO NOT TOUCH THE HOT TUBE THAT HAS JUST BEEN
RUNNING!
The previously selected tube will be automatically
turned off and the new tube will be energized. The
supply contacts are not energized if an empty location
is at the energizing station.
Tube at energizing station
Changing the selected tube
Removing the tube
To remove a tube, rotate the carousel until the tube to
be removed aligns with the tube insertion aperture. The
tube can then be removed by placing a finger under the
top ledge of the illuminated area and lifting the unit until
its top can be grasped from above and lifted out.
ALWAYS ALLOW A HOT TUBE TO COOL BEFORE
REMOVING IT, BECAUSE OF THE DANGER OF BURNS.
Use with Digital Spectrometers
An accessory for holding the end of a fiber optic digital
spectrometer probe in place in front of the spectrum
tube is available separately. Consult your distributor.
Maintenance
The system needs no special maintenance. It should
be stored in a dry, dust-free environment. For repairs
or replacement parts, contact us. Do not return any
item without prior authorization from us. Replacement
spectrum tubes are available.
Available tubes and Accessories
Tubes for the system are available with the following
gases and vapors. Contact us to obtain tubes.
Gas species
Item number
Air
P2-9900-01
Argon
P2-9900-02
Carbon Dioxide P2-9900-03
Helium
P2-9900-04
Hydrogen
P2-9900-05
Neon
P2-9900-06
Nitrogen
P2-9900-07
Water
P2-9900-08
Supply voltage contacts
Removing a tube
