- 62 -
BIOS
3.6 Save & Exit
Exit system setup after saving
the changes.
Version 2.14.1219. Copyritght (C) 2011 American Megatrends, Inc.
Advanced
Chipset
Boot
Security
Save & Exit
Aptio Setup Utility - Copyright (C) 2011 American Megatrends, Inc.
Main
: Select Item
: Change Opt.
+/-
: Previous Values
F2
: General Help
F1
: Save & Exit Setup
F10
: Exit
ESC
: Select Screen
: Select
Enter
: Optimized Defaults
F9
Save Changes and Exit
Discard Changes and Exit
SATA SM: GLS85LS1008A CS 08GB
Restore Defaults
Boot Override
Boot Override
Restore Defaults
This group of functions includes a list of tokens, each of them corresponding
to one device within the boot order. Select a drive to immediately boot that
device regardless of the current boot order.
Restore system to factory default.
Pressing <Enter> on this item and it asks for confirmation prior to executing
this command.
Save Changes and Reset
Pressing <Enter> on this item and it asks for confirmation:
Save configuration changes and exit setup?
Pressing <OK> stores the selection made in the menus in CMOS - a special
section of memory that stays on after you turn your system off. The next
time you boot your computer, the BIOS configures your system according to
the Setup selections stored in CMOS. After saving the values the system is
restarted again.
Summary of Contents for EasyBoard-650E
