- 10 -
Installation & Configuration
2.3 DIN-Rail Mounting
The DIN-rail mounting clip is screwed on the SCP Cube in the factory. To DIN
mount the SCP Cube:
1. Snap the DIN Rail clip to the upper edge of the DIN Rail.
2.
Press the SCP Cube firmly downward towards the DIN Rail until the DIN
Rail clip tab engages and snaps to the bottom edge of the DIN Rail.
DIN Rail
2.4 Monitoring Power Status
Prerequisites
The SCP Cube comes with a Windows-based monitoring utility to monitor the
SCP Cube power status. You can also use the utility to configure the shutdown
mode and timeout settings.
To use the utility, make sure your industrial PC system meets the following
requirement:
•
Windows system with
.NET Framework 3.5
or above installed.
Summary of Contents for SCP Cube
