- 11 -
Installation & Configuration
•
USB-to-COM driver installed:
This is required only if the SCP Cube is
connected to your industrial PC system via USB port. To install the driver:
1. Visit ARBOR website and locate the driver page of the SCP Cube.
Download the driver and save it to the industrial PC.
2. Extract the files. Double-click the
CDM21226_Setup.exe
file and follow
the on-screen instructions to complete the installation.
•
Download the SCP Cube utility.
Visit ARBOR website and locate the driver page of SCP Cube. Download
exe file of the
SCP Cube Utility
and save it to the industrial PC.
Monitoring SCP Cube Power Status
Run the exe file of the
SCP Cube Utility
to launch the utility, and then on the
Status
tab you can view the SCP Cube power information.
The following information are provided:
•
COM port:
The number of the COM interface connected to the SCP Cube.
•
FW version:
The firmware version of the SCP Cube.
•
Status:
The charging status of the SCP Cube.
•
Fully Charged:
The SCP Cube is fully charged from the connected
power system.
Summary of Contents for SCP Cube
