- 19 -
Operation Mode
3.3 Operation When DC Power Resumes
When the power resumes, the connected PC will restart automatically.
If not, please make sure to configure the PC's BIOS settings as described
below:
1. Open your computer's BIOS settings menu.
2.
Look for the Power Settings menu. Ensure the "
Power on after Power
Loss
" (or similar) setting is set to "
Power On
" as the example below:
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Version 2.15.1226. Copyright (C) 2012 American Megatrendes, Inc.
Super IO Configuration
Super IO Chip F71869A
►
Serial Port 1 Configuration
►
Serial Port
2 Configuration
Power On After Power Loss [Power On]
Set Parameters of
Serial Port 1 (COMA)
→←: Select Screen
↓↑: Select Item
Enter: Select
+/-: Change Opt.
F1: General Help
F2: Previous Values
F9: Optimized Defaults
F10: Save and Exit
ESC: Exit
Advanced
Aptio Setup Utility - Copyright (C) 2017 American Megatrends, Inc.
Version 2.18.1263. Copyright (C) 2017 American Megatrendes, Inc.
Summary of Contents for SCP Cube
