- 6 -
Installation & Configuration
2.1 Getting to Know the SCP Cube
2. COM Port
1. Status LED
3. USB Port
4. Power Output Switch
6. Power Output
7. Ground Screw
5. Power Input
8. DIN-Rail
Mounting Clip
No. Item
Descriptions
1
Status LED
Displays power & charging status. See below for details.
2
COM Port
RS-232 COM Port
To connect to industrial PC system for monitoring SCP Cube power status.
3
USB Port
USB 2.0 Port
To connect to industrial PC system for monitoring SCP Cube power status.
4
Power Output
Switch
Select 24V or 12V output voltage according to the power input of the
connected industrial PC system.
5
Power Input
DC 12~28V wide voltage power input
terminal block
To connect to the power source.
6
Power Output
Terminal Block
DC 24V or 12V power output terminal block
To connect to the power input of the industrial PC system.
7
Ground Screw Ground screw for ground connection.
8
DIN-Rail
Mounting Clip
For DIN-rail mounting.
Status LED
Group
Item
Color
Descriptions
PWR IN
(Top)
ON
Green
Solid: SCP Cube is connected to power source.
OFF
Red
Solid: SCP Cube is disconnected from power source.
Charging
(Middle)
Yellow
Solid: SCP Cube is charging from the power source.
Flashing: SCP Cube is exporting power to connected device.
Green
Solid: SCP Cube is fully charged.
PWR OUT
(Bottom)
24V
Green
Solid: SCP Cube power output is 24V.
12V
Blue
Solid: SCP Cube power output is 12V.
Summary of Contents for SCP Cube
