45 mm
L
56
0 m
m
M
- Installation (following the manufacturer’s instructions);
- When in doubt about operating the appliance;
- Replacing the electrical socket when it is not compatible with the appliance plug.
- The temperature probe is a part of thermostat, if damaged; the whole shall be replaced by authorized service
person.
Service Centers authorized by the manufacturer must be contacted in the following cases:
- If in doubt about the soundness of the appliance after removing it from its packaging;
- If the power supply cable has been damaged or needs to be replaced;
- If the appliance breaks down or functions poorly; ask for original spare parts.
It is a good idea to observe following:
- Steam cleaner cannot be used to clean the oven;
- Only use the appliance to cook food and nothing else;
- Check the soundness of the appliance after it has been unpacked;
- Disconnect the appliance from the electrical mains if it is not functioning properly and before cleaning or
performing maintenance;
- When left unused, unplug the appliance form the electricity mains;
- Use oven gloves to place cookware in the oven or when removing it;
- Always grip the oven door handle in the center as the extremities of the same may be hot due to any hot air
leak;
- Make sure the knobs are in the “ ”/“ ”position when the appliance is not in use;
- Disconnect the power cable from the mains when you decide not to use the appliance any longer.
F
The manufacturer will not be held responsible for any damage due to :Incorrect installation, improper, incorrect
and irrational use.
Installation
The oven should be installed by a qualified person.
The manufacturer declines all responsibility for improper
installation, which may harm persons, animals and damage property.
Important:
- The power supply to the appliance must be cut off before any adjustments or maintenance work is
done on
it;
- Air duct is supposed to be for Ventilation.
Installation of Built-in Ovens
In order to ensure that the built-in appliance functions properly, the cabinet containing it must be appropriate .The
figure below gives the dimensions of the cut-out for installation under the counter or in a wall cabinet unit.
N. B: Installation in compliance with the consumption declaration
In order to ensure adequate ventilation ,the back panel of the cabinet unit must be removed .Installing the oven
so that it rests on two strips of wood is preferable .If the oven rests on a continuous ,flat surface ,there must be an
aperture of at least 45
N
560mm .
