3
2
1
F
F
Timer
The longest time frame can be set is 23 hours and 59 minutes. For setting time, press the function button
repeatedly until the square symbol above “ ” flashes, and press “+” or “-” button until the time supposed shows
on the display. After
setting, the proper time (hour, minute) and the square symbol above the “ ” begins to flash. In addition, the
time
countdown begins to work. When it reaches the set time, the square symbol above the “ ” flashes, and the
alarm will ring, the square symbol will flash. To stop the ringing press any button.
Note:
press the relevant button, the setting must be carried out in 5 seconds; if electricity failure suddenly, all the
set procedure and the proper clock time (hour, minute) will disappear.
After electrical power is on again, “12:00” and the square symbol above “ ” will show on the display, you need
to set it again.
The oven light
Set knob
G
B
H
to the symbol to turn it on .It lights the oven and stays on when any of the electrical heating
elements in the oven comes on.
Cooling ventilation
In order to cool down the exterior of the appliance, this model is equipped with a cooling fan, which comes on
automatically when the oven is hot.
When the fan is on, a normal flow of air can be heard exiting between the oven door and the control panel.
Note: When cooking is done, the fan stays on until the oven cools down sufficiently.
How to Keep Your Oven in Shape
Before cleaning your oven, or performing maintenance, disconnect it from the power supply.
To extend the life of your oven, it must be cleaned frequently, keeping in mind that:
I
the enameled or stainless steel parts should be washed with lukewarm water without using any abrasive
powders or corrosive substances which could ruin them ;Stainless steel could get stained .If these stains are
difficult to remove, use special products available on the market. After cleaning, it is advisable to rinse thoroughly
and dry.
F
the inside of the oven should preferably be cleaned immediately after use ,when it is still warm ,with hot water
and soap ;The soap should be rinsed away and the interior dried thoroughly. Avoid using abrasive detergents (for
example cleaning powders, etc) and abrasive sponges for dishes or acids (such as lime scale –remover, etc…)
as these could damage the enamel .If the grease spots and dirt are particularly tough to remove, use a special
product for oven cleaning, following the instructions provided on the packet. Never use a steam cleaner for
cleaning inside of oven.
F
if you use your oven for an extended period of time ,condensation may form .Dry it using a soft cloth.
F
there is a rubber seal surrounding the oven opening which guarantees its perfect functioning .Check the
condition of this seal on a regular basis .If necessary, clean it and avoid using abrasive products or objects to do
so. Should it become damaged, please contacts you’re nearest After-sales Service Center .We recommend you
avoid using the oven until it has been repaired.
F
never line the oven bottom with aluminum foil ,as the consequent accumulation of heat could compromise the
cooking and even damage the enamel .
F
clean the glass door using non-abrasive products or sponges and dry it with a soft cloth .
How to Remove The Oven door
For a more thorough clean, you can remove the oven door. Choose the remove and assemble method
According to different structure of oven door purchased. Proceed as follows:
Oven door structures 1 remove and assemble procedure:
F
Open the door fully ;
F
Lift up and turn the small levers situated on the two hinges ;
F
Grip the door on the two external sides ,shut it slowly but not
Completely;
F
Pull the door towards you ,pulling it out of its seat ;
Reassemble the door by following the above procedures backwards.
Oven door structures 2 remove and assemble procedure:
