background image

SAFETY NOTES 

Please  read  through  the  instructions  carefully  before  using  this  radio.  Pay  much  attention  to  all 
precautions and warnings to ensure the safest operation. 
 
WARNINGS 
Do  not  fly  in  the  rain  or  at  night.  Water  can 
permanently damage many of the components 
in the radio system, possibly causing loss of the 
control and a crash. 
 
Only  fly  at  designated R/C  flying fields.  Fly  at 
safe distances away from other people, objects 
in the air, buildings, electrical lines, or any other 
object which could possible impede safe flying. 
Failure  to  do  so  could  cause  a  crash  and 
possibly  bodily  harm  and  physical  damage  to 
other property. 
 
Always test the radio system before use. Make 
sure the operation of each channel in the radio 
is in the proper direction. If a channel does not 
accurately respond according to the transmitter 
input,  do  not  fly  the  model.  Check  for  and 
correct  improperly  functioning  equipment 
before  use.  Failure  to  ensure  proper  radio 
operation before flight could result in a crash. 
 
During  flight  preparations,  be  certain  to  place 
the transmitter on its back when on the ground, 
to prevent it from accidentally falling over and 
inadvertently  moving  the  throttle  stick  to  high 
speed. 
 
Do  not  allow  fuel  or  oil  on  the  plastic  parts. 
Some plastics may melt when exposed to such 
material. 
Before  turning  on  the  transmitter,  adjust  the 
throttle stick to minimum speed position. After 
stopping the engine turn “OFF”, the transmitter 
power  switch,  then  turn  “Off”  the  transmitter 
power switch. Failure to follow this order could 
cause the engine to go to full throttle and cause 
an injury. 
 
Do not make adjustments to the radio system 

while  the  engine  is  running  unless  absolutely 
necessary.  Failure  to  do  so  could  cause  the 
engine  to  accidentally  go  to  high  speed  and 
cause an injury. 
 
The transmitter is designed for use with 8 dry 
cell  (Non-rechargeable)  AA  size  alkaline 
batteries or rechargeable NiMh cells (available 
separately).  If  using  rechargeable  batteries, 
please follow the charging instructions supplied 
by the manufacturer of the batteries.     
 
Never  attempt  to  charge  non-chargeable 
alkaline  dry  cell  batteries  as  there  is  a  risk  of 
fire, damage and personal injury. 
 
Always full charge the transmitter and receiver 
battery before each flight. Failure to do so could 
cause an inadvertent power failure and a crash. 
Use the charger supplied with this supplied with 
this  radio.  If  using  another  charger,  do  not 
overcharge the battery, as it could cause burns, 
fire, injury or other equipment damage. Do not 
short  circuit  the  battery  terminals,  as  arcing, 
overheating or fire could result. 
 
Do not leave the radio system, batteries, model 
helicopter or other equipment within the reach 
of children. 
 
Do not overheat or throw the batteries into a fire. 
Leaking  electrolyte  from  the  battery  could 
cause  injury,  such  as  burns  or  blindness.  In 
case of emergency, immediately flush you eyes, 
skin  or  cloths  with  plenty  of  water  and  see  a 
doctor. Recycle  the battery when no longer in 
usable condition. 
 
Store  the  radio  with  all  NiMh  batteries  in  the 
discharged  state  and  be  certain  to  full  charge 
the batteries just prior to use. 

 
 
 

Summary of Contents for AT401








Reviews: