SET-UP AND SAFE OPERATING PROCEDURES
10-35
89210000
CLIMBER V-A TRACTOR
Model V-A increases rigidity over previous models. Use four-wheel assemblies spaced farther
apart for greater stability. Adjustment for track width is easier to perform. This tractor must
be attached at the end of the track, then freewheeled into position. When using the tractor
out of position, in a particular vertical position, be sure to restrain the tractor when in the
freewheel mode.
Specifications
Length
15-
1/4
” (38,7cm)
Width
11-
1/2
” (29.2cm)
Height
7” (17,8cm)
Weight
16.3lbs. (7.4kg)
Motor
Permanent Magnet DC, Parallel Shaft,
1/30
Hp,
55in. lbs. Torque
Speed
0 to 100 in./min.
Load
Flat Position: 100lbs.
Horizontal Position: 75lbs.
Vertical Position: 30lbs.
Overhead Position: 75lbs.
Input
120VAC, 66Hz or 220VAC, 50Hz
TRACK
The track is made of a hard aluminum alloy for lightness and durability. Interlocking ends
permit quick joining and alignment. Special bolts and knurled nuts connect sections. Mounting
pads supplied with the magnet clamps space the track above the work for necessary tractor
clearance.
• Track lengths: 3 ft.(.9 m), 6 ft.(1.8 m), 10 ft.(3.05 m)
MAGNET CLAMP ASSEMBLIES
Magnet Assemblies are shipped with keepers. These should be removed before attaching the
magnets to the work. There is a quick release lever on each magnet. When this lever is pushed
to the horizontal position it raises one side of the magnet, breaking contact and permitting
easy removal. When working with the equipment out-of-position, use safety attachments to
prevent accidental falls due to surface or magnet contamination.
APPLICATIONS
The most common is the N6000 System. Used with automatic CAC-A, the tractor can be
mounted on a fixed beam track to do girth and longitudinal seams, arc machining and edge
preparations. Other uses are with oxy-fuel machine torches, welding torches, arc or flame
spraying equipment, and painting equipment. All work can be done in the vertical, horizontal
or overhead position. Work can also be done using magnet or vacuum attachments for each
track sections.
ArcairClimber V_A Travel System