Arcam CR 9000, Operating Manual

Using Your Remote

9

Note:  

SET appears in the LCD for 20 seconds to indicate that the remote

control is ready to be programmed. The following steps must be entered
while SET appears in the LCD. 

4

Point the remote control toward the device that was turned on in Step 1 and press
in the first three-digit Set Up Code number for that device using the number
buttons (0-9) on the remote control. SET followed by the number will appear in
the LCD. 

Your device will turn off when the correct Set-Up Code number has been selected.
If the device does not turn off, press in the next Set-Up Code number from the
listing. Continue to select Set-Up Code numbers until your device turns off, before
you proceed to Step 5. 

Note:

 If you have tried all of the three digit Set-Up Code numbers listed

for your device and it still did not turn off, please proceed to the Auto
Search Method on page (10) to program your remote control.

5

Once your device turns off, press the Device Button selected in Step 3 once again
to store the Set-Up Code number. PASS will flash in the LCD. 

6

Test the remote control for your device. Try the POWER, CHANNEL Up and
Down, VOLUME Up and Down buttons, etc. If any of the buttons do not perform
as they should, please repeat the set-up from Step 1 using the next Set-Up Code
number for your device.

Note:

 Some audio/video devices have separate buttons for POWER ON

and POWER OFF. To operate these devices on the remote, press the
corresponding device button to turn the equipment ON and press the
POWER button to turn the equipment OFF.

7

Please repeat the above steps to program the remote control for each of your
other devices.

Using Your Remote

10

Auto Search Method

Please use this method if none of the Set-Up Code numbers worked for your device
during the standard set-up procedure or if the manufacturer or brand for your device is
not listed in Set-Up Code Tables. 

1

Turn on the device you would like the remote control to operate, either manually
or with your original remote control.

2

Press the corresponding Device Button (TV, VCR, SAT, CBL, AUD, CD, DVD,
or AUX) and the MUTE button, simultaneously. SET will appear in the LCD.

Note: SET appears in the LCD for 20 seconds to indicate that the remote
control is ready to be programmed. The following steps must be entered
while SET appears in the LCD.

3 

Point the remote control toward the device and press the CHANNEL Up button on
the remote control. Each button press sends the signal for one Set-Up Code
number. Keeping the CHANNEL Up button pressed produces a quick scanning of
the Set-Up Code numbers.

Release the CHANNEL Up button as soon as the device turns off. Please confirm
that you have the correct code by pressing the MUTE button on the remote. You
should be able to turn your device on and off with this button.

Mute Button

Device Button

s

Channel Button

s