background image

ALJ2TB User Manual 

rev. 12/03/19

INSPECTION

Visual inspection should be made before each use of the jack, checking for leaking hydraulic fluid and damaged, loose or missing 

parts. Any jack which appears to be damaged in any way, is found to be badly worn, or operates abnormally MUST BE REMOVED 

FROM SERVICE until necessary repairs are made. 

SETUP (Refer to page 6 to identify reference numbers)

1.  Depress the spring button at the bottom of the (32) handle half and insert it in the (33) lower handle half until the 

spring button engages the hole in the lower handle half.
2.  Remove the (35) handle set screw from the (36) handle yoke. Install the assembled handle into the (36) handle yoke 

making sure the bottom of the handle engages the release valve u-joint (40).
3.   Install the (35) handle set screw in the (36) handle yoke and tighten the screw to secure the handle in the yoke. 

IMPORTANT:

 In most cases the jack should work normally right out of the box but it is not unusual for air to get trapped 

in the jack’s hydraulic system during shipping and handling. There are several symptoms of an air trapped hydraulic 

system which include only partial incremental pump stroke, jack will not lift load, jack will not sustain load or pumping 

feels spongy under load. The following procedure will purge air from the hydraulic system and only needs to be done if 

experiencing the above mentioned conditions.
   a)  The (3) saddle should be in its lowest position. Remove the oil filler plug in the reservoir of the (41) hydraulic   

 

 

power unit.

 

b)  Look inside the oil fill plug hole. You should be able to see the top of the power unit’s cylinder. The hydraulic   

 

 

fluid level should be no higher than the top of the cylinder. Correct the fluid level if it is not at the proper height. 

 

 

CAUTION: In order to prevent seal damage and jack failure, never use alcohol, hydraulic brake fluid, or  

 

 

 

transmission oil in the jack. Use hydraulic jack oil, a light turbine oil, Chevron Hydraulic Oil AW ISO 32 or Unocal  

 

 

Unax AW 150.

Handle
Socket

Saddle

Lift

Arm

Handle
Socket

Handle Socket
Bolt

Front
Wheels

Rear
Casters

Upper
Handle
Lock

Lower
Handle
Bumper

Lower
Handle

Upper
Handle

Reviews: