Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
93
coordinate, the system will set it 0.
G00
、
G01
、
G02
、
G03 can be simplified: G0
、
G1
、
G2
、
G3.
If there is contiguous G00 (or G01
、
G02
、
G03) around, the following G00 (or G01
、
G02
、
G03) can be ignored.
10.4 M Code Explanation
Table 10.3 Common M code
M07
No parameter
Cutting device on
M08
No parameter
Cutting device off
M00
No parameter
End of instruction
M02
No parameter
End of program
M07 Cutting device on
Ignition
Torch
Preheat oxygen
Incision oxyen
Acetylene
1 2 3
4
5 6
7
Fig 10.6 sketch map of cutting device on
1.
If acetylene hasn’t been open, open it.
2.
Open ignition and delay “ignition delay time”.
3.
Open torch down and delay “torch down time”.
4.
Close torch down, open preheat oxygen and delay “preheat delay time”. If in the
processing of preheat, press “STOP” key, the preheat time will be automatically delayed.
