29
CNC System Instruction
3. Automatic Function Interface Instruction:
In the main menu, press
【
F1
】,
to enter the automatic processing interface, as shown in sketch below:
3.1 Strong Electric Output Key Description:
【
IGNITE
】:
If you open the perforation operation, this button will be highlighted;
【
GAS
】:
If you open the cutting oxygen operation, this button will be highlighted;
【
TORCH UP
】:
If you do torch lifting, this button will be highlighted;
【
CUT
】:
If you do torch dropping, this button will be highlighted;
【
TORC DN
】:
If you turn the gas on, this button will be highlighted;
【
HOT UP
】:
If you open the cutting oxygen operation, this button will be highlighted;
【
X
】——
TEST:
Press this key, the system runs the program at top speed without executing M instructions. This function is
used to quick positioning, or check the steel processing range. Operation can be suspended at any time, press [K] key to cancel
test.
【
F
】——
ADSPEED:
drop
-
down menu appears, use
【↑】, 【↓】
keys to scroll through the 5%, 20%,30%, 40 %, 50 %,
60 %, 80%, 100%, 8 files in one, and then press Enter.
【
G
】——
CONTIN:
select Manual continuous ( highlighted ) when you press the arrow keys to adjust the position of the
torch , click the button to turn on or off; When you need two axes move simultaneously, press the arrow key of the other axis. At
this point, press any arrow key will stop the other axis, the current axis continues moving until press the arrow key again. Press
[Pause] also cause the motion stop; when manual continuous is not an option, press down arrow key will cause the torch move,
and release the key will stop it.
ESC
SECTION
MANUAL
RE
-
BREAK
VIEW
KERF
OTHERS
RETURN
SPEED
：
F*030%=1500
SPEED= 0
PIERCE
CUT
TORCH UP
TORCH DN
GAS
HOTUP
X
TEST
Y
AU
-
SPEED
1
200MIN
2
200MOUT
F
ADSPED
G
CONTINUE
ANGLE: 0.00
PROPORT:
INPUT:
○○○○○○○○
OUTP:UT:
○○○○○○○○
X 00000.000
WORK MODE
Y 00000.000 OPERATE
SET VOLTAGE: 120
REAL VOLTAGE: 000
PROPORT.: 1.0
HOTUP TIME: 100
BEG,ORW: 0.00
DISTANCE: 100
MACHINE X: 00342.043
MACHINE Y: 00002.588
PROG: Square1.TXT PIERCE N: 0000 KERF : 0.0 M:
AUTO
X&Y axis Coordinates display
Pattern view area
Program: cutting file
F=Max Speed
SPEED: instant speed for current cut
System Command
display area
Some Key Button
Function X/Y/1/2/F/G
System Command
Output display area
1
-
M38,
2
-
M12,
3
-
M14,
4
-
M16
