Service Support Spirit
Unique Solution
WWW.ARCBRO.COM
Load G code or graphics
→
Press the green
【
start
】
button
→
Ignition with a flame igniter
→
Waiting for Preheat
→
See redness steel reaches the molten state;
→
Press
【
Cut
】
key then Start flame
cutting;
Repeatedly adjust the intensity of the flame, the pressure of cutting oxygen, the cutting speed,
and the height of the cutting to optimize the cutting effect.
Step 3- Start formal flame cutting;
Load G code or graphics
→
Press the green
【
start
】
button
→
Ignition with a flame igniter
→
Waiting for Preheat
→
See redness steel reaches the molten state;
→
Press
【
Cut
】
key then Start flame
cutting;
Note
:
If the preheat time is not modified, the system will automatically remember the last preheat
time, the next time the cutting machine runs the last preheat time and then automatically pierce-
cutting;
However, it is also possible to press the
【
Cut
】
button according to the preheat condition;
Then perforation-cutting
In the cutting process, you can adjust the cutting
speed according to home and end; adjust the
capacitance value of the CHC---control the height of
the torch
CHC
Adjust the
capacitance
value