EN
9
refrigerator, the upper drawer has to
be removed and placed on top of wire
rack. Power consumption stated for
your refrigerator has been determined
after removing the icebox, ice tray and
upper drawer as to allow maximum
69+.381M%=381>2/69A/<.<+A/<A236/
loading is highly recommended.
t
Airflow should not be blocked by
placing foods in front of the freezer
compartment fan. Foods should be
loaded by leaving minimum 5 cm space
in front of the protective fan grid.
cold pack
foodstuffs
foodstuffs
cold pack
3
Installation
B
In case the information
which are given in the user manual are
not taken into account, manufacturer
will not assume any liability for this.
Points to be paid attention
to when the relocation of the
refrigerator
1.
Your refrigerator should be
unplugged.Before transportation of your
refrigerator, it should be emptied and
cleaned.
2.
Before it is re-packaged,
shelves, accessories, crisper, etc. inside
your refrigerator should be fixed with
adhesive tape and secured against
impacts. Package should be bound
with a thick tape or sound ropes and
the transportation rules on the package
should be strictly observed.
3.
Original packaging and foam
materials should be kept for future
transportations or moving.
Before you start the refrigerator,
Check the following before you start
to use your refrigerator:
1.
Clean the interior of the
refrigerator as recommended in the
“Maintenance and cleaning” section.
2.
Connect the plug of the
refrigerator to the wall socket. When the
fridge door is opened, fridge internal lamp
will turn on.
3.
When the compressor starts to
operate, a sound will be heard. The liquid
and gases sealed within the refrigeration
system may also give rise to noise, even if
the compressor is not running and this is
quite normal.
4.
Front edges of the refrigerator
may feel warm. This is normal. These
areas are designed to be warm to avoid
condensation.
Electrical connection
Connect your product to a grounded
socket which is being protected by a fuse
with the appropriate capacity.
Important:
The connection must be in compliance
with national regulations.
t
The power plug must be easily
accessible after installation.
t
Electrical safety of your refrigerator
shall be guaranteed only if the earth
system in your house complies with
standards.
t
The voltage stated on the label
located at left inner side of your product
should be equal to your network voltage.
