EN
10
t
Extension cables and multi plugs
must not be used for connection.
B
A damaged power cable must
be replaced by a qualified electrician.
B
Product must not be
operated before it is repaired! There
is the risk of electric shock!
Disposing of the packaging
The packing materials may be dangerous
for children. Keep the packing materials
out of the reach of children or dispose of
them by classifying them in accordance
with the waste instructions stated by
your local authorities. Do not throw away
with regular house waste, throw away on
packaging pick up spots designated by
the local authorities.
The packing of your refrigerator is
produced from recyclable materials.
Disposing of your old
refrigerator
Dispose of your old refrigerator without
giving any harm to the environment.
t
You may consult your authorized
dealer or waste collection center of your
municipality about the disposal of your
refrigerator.
Before disposing of your refrigerator, cut
out the electric plug and, if there are any
locks on the door, make them inoperable
in order to protect children against any
danger.
Placing and Installation
A
If the entrance door of the room
where the refrigerator will be installed is
not wide enough for the refrigerator to
pass through, then call the authorized
service to have them remove the doors
of your refrigerator and pass it sideways
through the door.
1.
Install your refrigerator to a place
that allows ease of use.
2.
Keep your refrigerator away from
heat sources, humid places and direct
sunlight.
3.
If the product will be placed in
an alcove, remember to leave at least 5
cm clearance between the product and
the ceiling, rear wall and the side walls.
Check if the rear wall clearance protection
component is present at its location
(if provided with the product). If the
component is not available, or if it is lost
or fallen, position the product so that at
least 5 cm clearance shall be left between
the rear surface of the product and the
wall of the room. The clearance at the rear
is important for efficient operation of the
product.
4.
Place your refrigerator on an even
floor surface to prevent jolts.
