EN
12
4
Preparation
•
Your refrigerator should be installed
at least 30 cm away from heat sources
such as hobs, ovens, central heater
and stoves and at least 5 cm away
from electrical ovens and should not be
located under direct sunlight.
•
The ambient temperature of the
room where you install your refrigerator
should at least be 10°C. Operating your
refrigerator under cooler conditions is
not recommended with regard to its
efficiency.
•
Please make sure that the interior of
your refrigerator is cleaned thoroughly.
•
If two refrigerators are to be installed
side by side, there should be at least 2
cm distance between them.
•
When you operate your refrigerator
for the first time, please observe the
following instructions during the initial
six hours.
•
The door should not be opened
frequently.
•
It must be operated empty without
any food in it.
•
Do not unplug your refrigerator.
If a power failure occurs out of your
control, please see the warnings in
the “Recommended solutions for the
problems” section.
•
Original packaging and foam
materials should be kept for future
transportations or moving.
• The baskets/drawers that are
provided with the chill compartment
must always be in use for low energy
consumption and for better storage
conditions.
•
Food contact with the temperature
sensor in the freezer compartment may
increase energy consumption of the
appliance. Thus any contact with the
sensor(s) must be avoided.
•
In some models, the instrument
panel automatically turns off 5 minutes
after the door has closed. It will be
reactivated when the door has opened or
pressed on any key.
•
Due to temperature change as a
result of opening/closing the product
door during operation, condensation
on the door/body shelves and the glass
containers is normal
