10 / 28 EN
Refrigerator / User Guide
4
Installation
4.1 The right place for installation
Your product requires adequate air circulation to
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
clearance between the product and the ceiling,
rear wall and the side walls.
If the product will be placed in an alcove,
remember to leave at least 5 cm clearance
between the product and the ceiling, rear wall and
the side walls. Check if the rear wall clearance
protection component is present at its location (if
provided with the product). If the component is
not available, or if it is lost or fallen, position the
product so that at least 5 cm clearance shall be
left between the rear surface of the product and
the wall of the room. The clearance at the rear is
important for efficient operation of the product.
A
WARNING:
Do not use extension or multi
sockets in power connection.
B
WARNING:
The manufacturer assumes
no responsibility for any damage caused
by the work carried out by unauthorized
persons.
B
WARNING:
The product's power cable
must be unplugged during installation.
Failure to do so may result in death or
serious injuries!
A
WARNING:
: If the door span is too
narrow for the product to pass, remove
the door and turn the product sideways; if
this does not work, contact the authorized
service.
t1MBDFUIFQSPEVDUPOBGMBUTVSGBDFUPBWPJE
vibration.
t1MBDFUIFQSPEVDUBUMFBTUDNBXBZGSPNUIF
heater, stove and similar sources of heat and at
least 5 cm away from electric ovens.
t%POPUFYQPTFUIFQSPEVDUUPEJSFDUTVOMJHIUPS
keep in damp environments.
t5IFQSPEVDUSFRVJSFTBEFRVBUFBJSDJSDVMBUJPOUP
function efficiently. If the product will be placed
in an alcove, remember to leave at least 5 cm
distance between the product and the ceiling
and the walls.
4.2 Attaching the plastic wedges
*May not be applicable for all models
Use the plastic wedges in the provided with
the product to provide sufficient space for air
circulation between the product and the wall.
1.
To attach the wedges, remove the screws on
the product and use the screws provided with the
wedges.
2.
Attach 2 plastic wedges on the ventilation cover as
shown in the figure.
Read the “Safety Instructions” section first!