10 /25EN
Refrigerator / User Manual
4.1. Things to be done for energy saving
mehmet
A
Connecting the product to electric energy
saving systems is risky as it may cause
damage on the product.
t
Do not leave the doors of your refrigerator open for
a long time.
t
Do not put hot food or drinks in your refrigerator.
t
Do not overload the refrigerator, cooling capacity will
fall when the air circulation inside is hindered.
t
To be able store maximum food in the freezer
compartment of your refrigerator, the upper flap
and drawer must be removed and placed on top of
glass shelves. Power consumption stated for your
refrigerator has been determined after removing the
icebox, ice tray and flap and the middle drawer as
to allow maximum loading. Using the upper flap and
lower drawer while loading is highly recommended.
t
Depending on the features of your product, thawing
frozen food in fridge compartment will both provide
energy saving and preserve the food quality.
t
Airflow should not be blocked by placing foods in
front of the freezer compartment fan. Foods should
be loaded by leaving minimum 5 cm space in front
of the protective fan grid.
t
The temperature sensor in the freezer compartment
must not directly contact food packages. In case of
contact with the sensor, the power consumption of
the product may increase.
t
Since hot and humid air will not directly penetrate
into your product when the doors are not opened,
your product will optimize itself in conditions
sufficient to protect your food. In this energy saving
function, functions and components such as
compressor, fan, heater, defrost, lighting, display
and so on will operate according to the needs to
consume minimum energy while maintaining the
freshness of your foodstuff.
t
In case of multiple options are present glass
shelves must be placed so that the air outlets at the
backwall are not blocked, prefably air outlets are
remaining below the glass shelf. This combination
may help impoving air distribution and energy
efficiency.
4
Preparation
C
Inside of your product must be cleaned.
C
If two coolers are to be installed side
by side, there should be at least 4 cm
distance between them.
4.2. Initial use
Before starting to use your refrigerator, ensure that
all preparations are made in accordance with the
instructions in sections "Instructions for safety and
environment" and "Installation".
Run the product without putting any food for 6 hours
and do not open its door unless certainly required.
C
You will hear a noise when the compressor
starts up. The liquids and gases sealed
within the refrigeration system may also
give rise to noise, even if the compressor is
not running. This is normal.
C
It is normal that the front edges of
the refrigerator are hot. These areas
are designed to be warm to avoid
condensation.
