EN / 44
4 Installation
Right place for installation
Read the “Safety Instructions” sec-
tion first!
Your product requires adequate air circula-
tion to function efficiently. If the product will
be placed in an alcove, remember to leave at
least 5 cm clearance between the product
and the ceiling, rear wall and the side walls.
Check if the rear wall clearance protection
component is present at its location (if
provided with the product). If the component
is not available, or if it is lost or fallen, posi-
tion the product so that at least 5 cm clear-
ance shall be left between the rear surface of
the product and the wall of the room. The
clearance at the rear is important for efficient
operation of the product.
Do not use extension or multi sock-
ets in the power connection.
The manufacturer assumes no re-
sponsibility for any damage caused
by the work carried out by unauthor-
ized persons.
The product’s power cable must be
unplugged during installation. Failure
to do so may result in death or seri-
ous injuries!
If the door span is too narrow for the
product to pass, remove the door
and turn the product sideways; if
this does not work, contact the au-
thorized service.
• Place the product on a flat surface to
avoid vibration
• Place the product at least 30 cm away
from the heater, stove and similar sources
of heat and at least 5 cm away from elec-
tric ovens.
• Do not expose the product to direct sun-
light or keep keep in damp environments.
Attaching the plastic wedges
Use the plastic wedges provided with the
product to maintain sufficient space for air
circulation between the product and the wall.
• Remove the screws on the product and
mount the screws provided with the
wedges.
• Attach 2 plastic wedges on the ventilation
cover as shown in the figure.
Adjusting the Legs
If the product is not in a balanced position,
you can adjust the balance of the product by
rotating the stands on the front right or left.
Summary of Contents for 578590EI
Page 29: ...TR 29 Hizmet Talebinin Değerlendirilmesi TR EN ...
Page 31: ......
Page 59: ......
Page 60: ......