Microwave Oven / User Manual
10 / EN
2.3 Installing the turntable
•
Never place the glass tray upside down. The
glass tray should never be restricted.
•
Both glass tray and turntable support must al-
ways be used during cooking.
•
All food and containers of food must always
place on the glass tray for cooking.
•
If glass tray or turntable support crack or break,
contact your nearest authorized service center.
2 Your microwave oven
Göbek (alt kısım)
Cam tabla
Döner tabla desteği
Döner tabla mili
Hub (underside)
Glass tray
Turntable shaft
Turntable support
3 Installation and connection
3.1 Installation
1. Make sure that all the packing materials are re-
moved from the inside of the door.
A
WARNING:
Check the oven for any
damage, such as misaligned or bent
door, damaged door seals and seal-
ing surface, broken or loose door
hinges and latches and dents inside
the cavity or on the door. If there
is any damage, do not operate the
oven and contact qualified service
personnel.
2. This microwave oven must be placed on a flat,
stable surface to hold its weight and the heavi-
est food likely to be cooked in the oven.
3. Do not place the oven where heat, moisture, or
high humidity are generated, or near combus-
tible materials.
4. For correct operation, the oven must have suf-
ficient airflow. Allow minimum 20cm of free
space necessary above the top surface of the
oven and 5cm at both sides. The microwave
oven rear plate must be placed close to the
wall. Do not cover or block any openings on the
appliance. Do not remove feet.
5. Do not operate the oven without glass tray, roller
support, and shaft in their proper positions.
6. Make sure that the power supply cord is un-
damaged and does not run under the oven or
over any hot or sharp surface.
7. The socket must be readily accessible so that it
can be easily unplugged in an emergency.
8. Do not use the oven outdoors.
3.2 Radio interference
Operation of the microwave oven can cause in-
terference to your radio, TV, or similar equipment.
When there is interference, it may be reduced or
eliminated by taking the following measures:
1. Clean door and sealing surface of the oven.
2. Reorient the receiving antenna of radio or tel-
evision.
3. Relocate the microwave oven with respect to
the receiver.
4. Move the microwave oven away from the re-
ceiver.
5. Plug the microwave oven into a different outlet
so that microwave oven and receiver are on dif-
ferent branch circuits.
