26
This register determines the ASCII values as the carriage return character.
This character is used to end command lines and result codes.
Range: 0-127, ASCII decimal
Default: 13 (carriage return)
Units: ASCII
S4 Response Formatting Character (User Defined)
This register determines the ASCII value used as the line feed character. The
modem uses a line feed character in command mode when it responds to the
computer.
Range: 0-127, ASCII decimal
Default: 10 (line feed)
Units: ASCII
S5 Command Line Editing Character (User Defined)
This register sets the character recognized as a backspace and pertains to
asynchronous only.
Range: 0-127, ASCII decimal
Default: 8 (backspace)
Units: ASCII
S6 Wait Before Dialing
This register sets the length of time, in seconds, that the modem must wait
(pause) after going off-hook before dialing the first digit. The modem always
pauses for a minimum of two seconds, even if the value of S6 is less than two
seconds. Waiting for dial tone call progress features (W dial modifier in the dial
string) will override the value in register S6. This operation, however, may be
affected by some ATX options according to country restrictions.
Range: 2-10
Default: 2
Units: seconds
S7 Connection Completion Timeout
This register sets the time, in seconds, that the modem must wait before
hanging up because carrier is not detected. The timer is started when the
modem finishes dialing (originate), or goes off-hook (answer). In originate
mode, the timer is reset upon detection of an answer tone if allowed by country
restriction. The timer also specifies the wait for silence time for the @ dial
Summary of Contents for 5634PCV
Page 1: ...1 5634 PCV User s Manual ...