adjustment is completed, confirm the parameter by pressing the ‘selection knob’ or the system will confirm the
parameter automatically after 3 seconds.
Other parameters such as arc force adjustment: press the ‘selection knob’
;
Adjust the ‘selection knob’and select the
arc force LED (L13 is on); Press the ‘selection knob’again, the arc force LED(L13) is flashing It means the arc force can
be adjusted. If the adjustment is completed, press the ‘selection knob’and confirm the parameter; Or the system will
confirm the parameter automatically after 3 seconds. Operation flow as follows:
Step one: ‘Welding mode selection switch’ selects MMA mode, press the ‘selection knob’;
Step two: Adjust the ‘selection knob’and select the arc force LED (L13 is on); Press the ‘selection knob’again,
the arc force LED(L13) is flashing.; It means the arc force can be adjusted.
Step three: If the adjustment is completed, press the ‘selection knob’and confirm the parameter; Or the system
will confirm the parameter automatically after 3 seconds.
Welding mode
selection switch
select MMA
Press
the
‘selection knob’
If the adjustment is completed,
press the
‘
selection knob
’
and
confirm the parameter; Or the
system will confirm the
parameter automatically after
3 seconds.
Adjust the ‘selection knob’ and
select the arc force LED (L13 is
on); Press the ‘selection knob’
again, the arc force LED (L13)
is flashing; It means the arc
force value can be adjusted.