Output pulse selection: Press the ‘selection knob’. Adjust the ‘selection knob’and select the pulse LED (L11 is on);
press the ‘selection knob’ again, the pulse LED (L11) is flashing; It means the output pulse function can be turned on
or turned off. If the display is “ON”, the output pulse function is turned on; if the display is “OFF”, the output pulse
function is turned off. When the pulse LED (L11) is flashing, press the ‘selection knob’ again, the output pulsed
conditions transform by “ON” into “OFF” or transform by “OFF” into “ON”. Operation flow as follows:
Step one: ‘Welding mode selection switch’ select TIG 4T or 2T. Press the ‘selection knob’;
Step two: Adjust the ‘selection knob’and select the output pulse LED (L11 is on); press the ‘selection knob’ again, the
pulse LED (L11) is flashing; It means the output pulse function can be turned on or turned off.
Step three: Press the ‘selection knob’ again, the output pulsed conditions transform by “ON” into “OFF” or
transform by “OFF” into “ON”.
If the adjustment is complete,
confirm the parameter by
pressing the ‘selection knob’;
or the system will confirm the
parameter automatically after
3 seconds
Select TIG 4T or 2T
Press the ‘selection knob’
Adjust the
‘
selection knob
’
and
select the pulse LED (L11 is on);
Press the ‘selection knob’ again,
the pulse LED (L11) is flashing;
It means the output pulse function
can be turned on or turned off.