8.2 CPU module
Figure. 8.2 - 154. CPU module.
Module connectors
Table. 8.2 - 149. Module connector descriptions.
Connector
Description
COM A
Communication port A, or the RJ-45 port. Used for the setting tool connection and for IEC 61850, Modbus/
TCP, IEC 104, DNP3 and station bus communications.
COM B
Communication port B, or the RS-485 port. Used for the SCADA communications for the following protocols:
Modbus/RTU, Modbus I/O, SPA, DNP3, IEC 101 and IEC 103. The pins have the following designations: Pin 1 =
DATA +, Pin 2 = DATA –, Pin 3 = GND, Pins 4 & 5 = Terminator resistor enabled by shorting.
Model with 3 digital inputs
Model with 3 digital inputs
Model with 2 digital inputs
Model with 2 digital inputs
X 1
Digital input 1, nominal threshold voltage 24 V, 110 V
or 220 V.
Digital input 1, nominal threshold voltage 24 V, 110 V
or 220 V.
X 2
Digital input 2, nominal threshold voltage 24 V, 110 V
or 220 V.
GND for digital input 1.
X 3
Digital input 3, nominal threshold voltage 24 V, 110 V
or 220 V.
Digital input 2, nominal threshold voltage 24 V, 110 V
or 220 V.
X 4
Common GND for digital inputs 1, 2 and 3.
GND for digital input 2.
X 5:6
Output relay 1, with a normally open (NO) contact.
X 7:8
Output relay 2, with a normally open (NO) contact.
X 9:10
Output relay 3, with a normally open (NO) contact.
X 11:12
Output relay 4, with a normally open (NO) contact.
X 13:14:15
Output relay 5, with a changeover contact.
A
AQ
Q-S215
-S215
Instruction manual
Version: 2.04
252
Summary of Contents for AQ-S215
Page 1: ...AQ S215 Bay control IED Instruction manual...
Page 249: ...Figure 7 4 151 Example block scheme A AQ Q S215 S215 Instruction manual Version 2 04 248...
Page 269: ...Figure 8 13 172 Device installation A AQ Q S215 S215 Instruction manual Version 2 04 268...
Page 287: ...10 Ordering information A AQ Q S215 S215 Instruction manual Version 2 04 286...
