137
GZ405
7. Using an awl, rotate the C-ring in its groove until it is
out of the cylinder head; then remove the C-ring.
NOTE: Care should be taken not to drop the C-ring
into the crankcase.
GZ155
8. Bend the washer tabs down and remove the two cap
screws securing the sprocket to the camshaft; then
drop the sprocket off the camshaft being careful not
to drop the locating pin into the engine.
GZ154A
9. While holding the chain, slide the sprocket and cam-
shaft out of the cylinder head.
CC266D
NOTE: Loop the chain over the cylinder head and
secure it to keep it from falling into the crankcase.
GZ408
10. Remove the five nuts securing the cylinder head to
the cylinder; then remove the four cylinder head cap
screws and washers.
NOTE: Removing the starter will simplify removal of
the front cylinder base nuts.
GZ209A
11. Remove the cylinder head from the cylinder, remove
the gasket, and account for two alignment pins; then
remove the cam chain guide.
