229
AG925
4. Install the inner fender panels.
5. Install the front axles (see Drive Axles in this sec-
tion).
6. Secure the upper A-arms with cap screws and lock
nuts. Tighten to 50 ft-lb.
AF610D
7. Secure the lower shock eyelets with cap screws and
lock nuts. Tighten to 50 ft-lb.
AF897D
8. Secure the tie rods with the lock nuts. Tighten to 30
ft-lb; then install and spread the cotter pins.
AF896D
AF895D
9. Install the brake calipers and secure with new
“patch-lock” cap screws tightened to 20 ft-lb.
AF894D
10. Install the wheels and tighten to 40 ft-lb (steel
wheels) or 80 ft-lb (aluminum wheels).
11. Remove the ATV from the support stand.
Drive Axles
REMOVING REAR DRIVE AXLE
1. Secure the ATV on a support stand to elevate the
wheels.
! WARNING
Make sure the ATV is solidly supported on the support
stand to avoid injury.
