36
CF226A
NOTE: The rear seat must be removed prior to
removing the front seat.
5. To remove the front seat, pull the seat lock lever up
(located at the rear of the seat). Raise the rear end of
the seat and slide it rearward.
6. To lock the seat into position, slide the front of the
seat into the seat retainers and push down firmly on
rear of seat. The seat should automatically lock into
position.
Side Storage Box
(TBX)
REMOVING
1. Rotate the cargo box latch handle (located on the left
and right sides between the cargo box and the rear
tire) and fully raise the cargo box.
2. Pull the seat lock lever forward (located below the
right side of the seat), raise the front end of the seat,
and slide it forward and off the ATV.
3. Remove the two cap screws (located inside the side
storage box) securing the box to the footrest.
4. Remove the screw securing the box to the side panel.
5. Remove cap screws (A and B) securing the box to
the frame.
CD045A
CLEANING AND INSPECTING
1. Clean all side storage box components with soap and
warm water.
2. Inspect the box for cracks, tears, and loose mounting
hardware.
3. Inspect the box hatch O-ring seals for cuts or tears.
INSTALLING
1. Place the side storage box into position on the frame;
then secure with the two cap screws (A and B).
Tighten cap screws to specifications.
CD045A
2. Secure the box to the side panel with the existing
screw.
3. Secure the box to the footrest with existing hard-
ware. Tighten securely.
4. Install the seat.
5. Lower the cargo box and press down firmly on the
front of the box. The cargo box will automatically
lock into position.
Cargo Box (TBX)
REMOVING
1. Rotate the cargo box latch handle (located on the left
and right sides between the cargo box and the rear
tire) and fully raise the cargo box.
CD771
