4
Gasoline - Oil - Lubricant
RECOMMENDED GASOLINE
The recommended gasoline to use is 87 minimum octane
regular unleaded. In many areas, oxygenates are added to
the gasoline. Oxygenated gasolines containing up to 10%
ethanol or 5% methane are acceptable gasolines.
When using ethanol blended gasoline, it is not necessary
to add a gasoline antifreeze since ethanol will prevent the
accumulation of moisture in the fuel system.
RECOMMENDED ENGINE/
TRANSMISSION OIL
The recommended oil to use is Arctic Cat ACX All
Weather synthetic which has been specifically formu-
lated for use in this Arctic Cat engine. Although Arctic
Cat ACX All Weather synthetic engine oil is the only oil
recommended for use in this engine, use of any API certi-
fied SM 0W-40 oil is acceptable.
OILCHARTJ
RECOMMENDED FRONT
DIFFERENTIAL/REAR DRIVE
LUBRICANT
The recommended lubricant is Arctic Cat Gear Lube or an
equivalent gear lube which is SAE approved 80W-90 hyp-
oid. This lubricant meets all of the lubrication requirements
of the Arctic Cat ATV front differentials and rear drives.
FILLING GAS TANK
Since gasoline expands as its temperature rises, the gas tank
must be filled to its rated capacity only. Expansion room
must be maintained in the tank particularly if the tank is
filled with cold gasoline and then moved to a warm area.
Tighten the gas tank cap securely after filling the tank.
Genuine Parts
When replacement of parts is necessary, use only genuine
Arctic Cat ATV parts. They are precision-made to ensure
high quality and correct fit. Refer to the appropriate Illus-
trated Parts Manual for the correct part number, quantity,
and description.
Preparation For Storage
Arctic Cat recommends the following procedure to pre-
pare the ATV for storage.
1. Clean the seat cushion (cover and base) with a damp
cloth and allow it to dry.
2. Clean the ATV thoroughly by washing dirt, oil,
grass, and other foreign matter from the entire ATV.
Allow the ATV to dry thoroughly. DO NOT get
water into any part of the engine or air intake.
3. Either drain the gas tank or add Fuel Stabilizer to the
gas in the gas tank. Remove the air filter housing
cover and air filter. Start the engine and allow it to
idle; then using Arctic Cat Engine Storage Preserver,
rapidly inject the preserver into the air filter opening
for a period of 10 to 20 seconds. Stop the engine.
Install the air filter and housing cover.
CAUTION
Do not use white gas. Only Arctic Cat approved gaso-
line additives should be used.
CAUTION
Any oil used in place of the recommended oil could cause
serious engine damage. Do not use oils which contain
graphite or molybdenum additives. These oils can
adversely affect clutch operation. Also, not recommended
are racing, vegetable, non-detergent, and castor-based oils.
CAUTION
Any lubricant used in place of the recommended lubricant
could cause serious front differential/rear drive damage.
! WARNING
Always fill the gas tank in a well-ventilated area. Never
add gasoline to the ATV gas tank near any open flames
or with the engine running. DO NOT SMOKE while filling
the gas tank.
! WARNING
Do not overflow gasoline when filling the gas tank. A
fire hazard could materialize. Always allow the engine to
cool before filling the gas tank.
! WARNING
Do not over-fill the gas tank.
CAUTION
Prior to storing the ATV, it must be properly serviced to
prevent rusting and component deterioration.
CAUTION
If the interior of the air filter housing is dirty, clean the
area before starting the engine.
