DIV
ISION
II -
OPER
A
T
ION
/
MAINTENANC
E
53
Handwarmers/
Thumbwarmer (Cruiser)
The operator’s handwarmers/thumb-
warmer are controlled by a rocker-type
switch on the instrument pod. There are
three positions on the switch (Low/Off/
High).
CR027C
The passenger’s handwarmers are con-
trolled by a rocker-type switch located
beneath the right-side handgrip. There
are three positions on the switch (Low/
Off/High).
CR009A
NOTE: Operating handwarmers,
lights, and/or other accessories at low
engine RPM for extended time may
cause excessive battery discharge
resulting in erratic engine operation.
Hand Brake
The hand brake is considered to be the
normal operating (main) brake. It should
be applied whenever a braking situation
is needed.
Apply the brake by compressing the
brake lever toward the handlebar.
Brake Lever Lock
To engage and release the brake lever
lock, use the following procedure.
738-420B
1. Squeeze the hand brake two or three
times and release it.
2. Depress and hold the brake lever
lock.
3. While holding in on the brake lever
lock, squeeze the brake lever.
NOTE: It will click as it engages
and the brake lever will not return
to its released position.
4. Release the brake lever lock by
squeezing the brake lever. It will
return to its released position.
! WARNING
The 4WD lock is intended for use
where minimum traction is available.
NEVER EXCEED 10 MPH (16 kph)
with the lock engaged. Maneuverabil-
ity and handling characteristics will
differ with the lock engaged. ALWAYS
shift into four-wheel drive prior to
engaging the front differential lock.
Failure to follow this procedure may
result in loss of control. Control loss
can result in severe injury or even
death.
CAUTION
Always charge a discharged battery
prior to storage or severe battery
damage may occur (See GENERAL
MAINTENANCE - BATTERY in this
manual.