56
Speedometer/LCD
(Digital)
CF236A
1. Clock/Engine Hour Meter - The
clock function indicates time in the
12-hour mode; the hour meter indi-
cates the total time the ATV has run
and cannot be reset to zero. To set
the clock, use the following proce-
dure.
A. With the ignition switch ON,
press and release the Mode But-
ton (3) until the Clock/Engine
Hour Meter (1) is displayed; then
(if necessary) press and release
the Set/Reset Button (4) to select
the clock display.
B. Press and hold the Set/Reset But-
ton (4) until the minutes stop
scrolling and the hour display
starts to scroll. Momentarily
release when the correct hour is
displayed; then repeatedly press
and release the Set/Reset Button
(4) until the correct minutes are
displayed.
NOTE: Clock memory power is
supplied through the 15-amp
accessory fuse and verified during
gauge “power-up” and reset. In the
event of clock memory power fail-
ure (blown fuse, etc.), the gauge
will “power-up,” reset, and shut
down repeatedly until clock mem-
ory power is restored. Always
check the 15-amp accessory fuse
if this gauge condition is noted.
NOTE: The engine hour meter
will not activate until engine speed
exceeds 500 RPM.
2. Temperature Indicator - If the engine
coolant temperature exceeds the nor-
mal operating range, the temperature
icon will begin flashing and the
LCD will go blank for 30 seconds;
then the LCD will return to normal.
However, the temperature icon will
continue to flash.
NOTE: High engine RPM, low
vehicle speed, or heavy load can
raise engine temperature. Decreas-
ing engine RPM, reducing load, and
selecting an appropriate transmis-
sion gear can lower the tempera-
ture.
NOTE: Debris in front of the
engine (or packed between the
cooling fins of the radiator) can
reduce cooling capacity. Using a
garden hose, wash the radiator
and the engine to remove any
debris restricting air flow.
3. Mode Button - Shifts the gauge
through three set-up modes: speed-
ometer/tachometer, distance, and
time.
NOTE: The Mode Button must be
pressed and released to shift
modes. Approximately two sec-
onds after the Mode Button is
released, the digital gauge will
return to full display.
CAUTION
Continued operation with high
engine temperature may result in
engine damage or premature wear.
CAUTION
Arctic Cat does not recommend
using a pressure washer to clean
the radiator core. The pressure may
bend or flatten the fins causing
restricted air flow, and electrical
components on the radiator could
be damaged. Use only a garden
hose with spray nozzle at normal tap
pressure.
