DIV
ISION
II -
OPER
A
T
ION
/
MAINTENANC
E
81
5. Switch on the lights. Make sure the
HIGH beam is on. DO NOT USE
LOW BEAM.
6. Observe each headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical
mark 5 cm (2 in.) below the horizon-
tal mark on the aiming surface.
7. Adjust each headlight by turning the
adjustment knob clockwise to raise
the beam or counterclockwise to
lower the beam until correct aim is
obtained.
CD714A
Fuses
The fuses are located in a fuse block
under the seat. If there is any type of
electrical system failure, always check
the fuses first.
NOTE: To remove the fuse, com-
press the locking tabs on either
side of the fuse case and lift out.
2411-090
2411-080
2411-081
2411-213
2411-214
Electrical Output
Terminals
Two output terminals for electrical acces-
sories are located on the front wiring har-
ness and one output terminal for electrical
accessories is located on the rear wiring
harness. The accessory plug is located on
the right side of the instrument pod.
Tool Storage Tray/
Battery Hold-Down
A basic tool kit is provided with the ATV.
450
550/700
CAUTION
Always replace a blown fuse with a
fuse of the same type and rating. If
the new fuse blows after a short
period of use, consult an authorized
Arctic Cat ATV dealer immediately.
CAUTION
Always use electrical accessories
less than 180W.
700 Cruiser
700s
1000s Cruiser