2-10
10. Install the oil level stick and thread into the engine
case.
NOTE: The oil level stick should be threaded into
the case for checking the oil level.
11. Remove the oil level stick; the engine oil level
should be above the illustrated “L” mark but not
higher than the illustrated “F” mark.
ATV-0100AA
12. Inspect the area around the drain plug and oil filter
for leaks.
Front Differential - Rear
Drive/Differential
Lubricant
To check lubricant, use the following procedure.
1. Remove the level plug; the lubricant level should
be visible at the plug threads.
PR530A
2. If low, add SAE approved 80W-90 hypoid gear
lube as necessary.
To change the lubricant, use the following procedure.
1. Place the vehicle on level ground.
2. Remove each fill/level plug.
3. Drain the lubricant into a drain pan by removing in
turn the drain plug from each.
ATV0082A
PR530B
4. After all the lubricant has been drained, install the
drain plugs and tighten to 45 in.-lb.
5. Pour the appropriate amount of recommended
lubricant into the fill/level hole.
6. Install the fill/level plugs.
NOTE: If the lubricant is contaminated with water,
inspect the drain plug, fill/level plug, and/or blad-
der.
Tires
TIRE SIZES
The UTV models are equipped with low-pressure
tubeless tires of the size and type listed in Section 1.
Do not under any circumstances substitute tires of a
different type or size.
! CAUTION
Do not over-fill the engine with oil. Always make
sure that the oil level is above the
“
L” mark but not
higher than the
“
F
”
mark.
! WARNING
Always use the size and type of tires specified.
Always maintain proper tire inflation pressure.
Front Differential
Rear Drive/Differential
Back to TOC
Back to Section TOC
Next
Back
