6-6
Assembling Input Shaft
1. Place the pinion housing in a press and install the
input shaft bearing. Secure the bearing with the
existing snap ring making sure the sharp edge of
the snap ring faces to the outside.
AF993
AF994
2. Install the input shaft seal making sure it is flush
with the edge of the housing.
3. Lubricate the input shaft splines with High-Perfor-
mance #2 Molybdenum Disulphide Grease.
NOTE: Any time drive splines are separated,
clean all splines with parts-cleaning solvent and
dry with compressed air; then lubricate with rec-
ommended grease.
KX221
KX222
4. Install the input shaft into the housing; then install
the front boot and secure with an appropriate boot
clamp and the rear boot with an appropriate boot
clamp.
CD112
5. Using a new O-ring lubricated with grease, install the
front drive actuator and secure with the cap screws.
6. Place the pinion housing with new gasket onto the
gear case housing; then secure with the existing
cap screws. Tighten to 18 ft-lb.
CD103
Disassembling Pinion Gear
NOTE: This procedure can be performed on a
rear gear case.
1. Remove the cap screws securing the pinion hous-
ing. Account for the coupler, fork, and spring.
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com