3-55
3
MT011A
2. Using a suitable press, install the driven gear (C)
on the shaft until the gear firmly seats on the
shoulder of the shaft.
MT011B
3. If installing the existing shaft, start with the shims
removed during disassembly or if installing a new
shaft, start with approximately 1.0 mm shims at
point (D); then install the output driveshaft bearing
(E) making sure the locating pin is directed toward
the center of the shaft.
MT012
MT008A
4. Install a new seal (F), output yoke (G), and nut (H)
and tighten to 72 ft-lb.
MT008B
NOTE: Do not use a new lock nut at this time as
this procedure may have to be repeated.
5. Place the assembled shaft into the left crankshaft
case; then lightly coat the gear teeth with machin-
ist’s lay-out dye. Rotate the shafts through several
rotations in both directions. Gear contact should
extend from the root to the top of the gear teeth.
DE657A
6. To adjust tooth contact, use the following chart to
correctly shim the secondary bevel drive gear.
7. After correct tooth contact is established, proceed
to Checking Backlash in this sub-section.
Tooth Contact
Shim Correction
Contact at Top
Increase Shim Thickness
Contact at Root
Decrease Shim Thickness
Next
Back
Section
Table of Contents
Manual
Table of Contents
FOR ARCTIC CAT ATV DISCOUNT PARTS CALL 606-678-9623 OR 606-561-4983
www.mymowerparts.com
