64
9. Connect the battery cables (positive
cable first); then install the battery
hold-down.
NOTE: Arctic Cat highly recom-
mends all ATV batteries be con-
nected to a maintenance charger
during storage or any extended
period of non-use. This charger
MUST have an automatic float, stor-
age-safe, or pulse maintenance
mode to avoid battery damage due
to long-term overcharging. To con-
nect the maintenance charger, use
any of the following procedures.
A. Remove the battery cover; then
connect the charger leads (posi-
tive cable first) directly to the
battery.
B. Locate the rear accessory con-
nector and connect the charger
leads (positive cable first)
directly to the connector.
C. Using an appropriate adapter,
connect the charger to any DC
power outlet.
Jump-Starting
NOTE: Arctic Cat does not recom-
mend jump-starting a vehicle with a
dead battery but rather to remove
the battery, service it, and correctly
charge it; however, in an emer-
gency, it may be necessary to jump-
start a vehicle. If so, use the follow-
ing procedure to carefully and
safely complete this procedure.
1. On the vehicle to be jump-started,
remove the battery cover and any ter-
minal boots.
2. Inspect the battery for any signs of
electrolyte leaks, loose terminals, or
bulging sides. Leaking or bulging bat-
tery cases may indicate a frozen or
shorted battery.
3. Inspect the vehicle to be used for
jump-starting to determine if voltage
and ground polarity are compatible.
The vehicle must have a 12-volt DC,
negative ground electrical system.
4. Move the vehicle to be used for the
jump-start close enough to ensure the
jumper cables easily reach; then shift
into neutral, set and lock the brakes,
shut off all electrical accessories, and
turn the ignition switch OFF.
NOTE: Make sure all switches on
the vehicle to be jump-started are
turned OFF.
CAUTION
Connecting cables in reverse (posi-
tive to negative and negative to posi-
tive) can cause serious damage to
the electrical system.
! WARNING
Improper handling or connecting of a
battery may result in severe injury
including acid burns, electrical burns,
or blindness as a result of an explo-
sion. Always remove rings and
watches.
! WARNING
Any time service is performed on a
battery, the following must be
observed: keep sparks, open flame,
cigarettes, or any other flame away.
Always wear safety glasses. Protect
skin and clothing when handling a
battery. When servicing battery in
enclosed space, keep the area well-
ventilated. Make sure battery venting
is not obstructed.
! WARNING
If any of these conditions exist, DO
NOT attempt a jump-start, boost, or
charge the battery. An explosion
could occur causing serious injury.
CAUTION
Always make sure the electrical sys-
tems are of the same voltage and
ground polarity prior to connecting
jumper cables. If not, severe electri-
cal damage may occur.
Summary of Contents for 2012 700 Diesel
Page 78: ...76 Maintenance Record DATE MILEAGE SERVICE PERFORMED NOTES ...
Page 85: ...83 NOTES ...
Page 86: ...84 NOTES ...