108
AF982
6. Remove the snap ring securing the input shaft bear-
ing; then place the pinion housing in a press and
remove the bearing.
AF983
AF984
KX219
Assembling Input Shaft
1. Place the pinion housing in a press and install the
input shaft bearing. Secure the bearing with the
existing snap ring making sure the sharp edge of the
snap ring faces to the outside.
AF993
AF994
2. Install the input shaft seal making sure it is flush with
the edge of the housing.
3. Lubricate the input shaft splines with High-Perfor-
mance #2 Molybdenum Disulphide Grease.
NOTE: Any time drive splines are separated, clean
all splines with parts-cleaning solvent and dry with
compressed air; then lubricate with recommended
grease.
KX221